4. Appendices
Restoring the user programs to
4. Appendices
the factory settings (Reload)
Adjusting the expression pedal
1. Turn on the power while simultaneously holding
(Calibration)down the EXIT switch and the bank switch. The
If you find the expression pedal difficult to use,name display will indicate ORELOAD?�
perform this procedure so that the pedal will functionIf you press the EXIT switch, the reload operation will not
occur; the power-on display will appear, and you will
optimally. For example if the effect does not reachenter Play mode.
maximum when the pedal is advanced all the way, or
2. Press the WRITE switch. The name display will
does not reach minimum when the pedal is returned
all the way, use the following procedure to make thechange to ORELOAD,� and the reload operation
appropriate adjustments.will begin. When the reload operation is completed,
the display will indicate OCOMPLT� for approxi-
When making adjustments, use your hand to move themately one second. Then the power-on display will
pedal. Accurate calibration may not be possible if you use
your foot to operate the pedal.appear, and you will enter Play mode.
Never turn off the power during the reload operation.
1. Turn on the power while simultaneously holding
down the EXIT switch and the PEDAL effect blockWhen you perform the reload operation, all user
select switch.The name display will show OPEDAL�programs will be rewritten. Master level, metronome, and
for approximately one second, and will theninput level settings will also be initialized.
indicate OMIN.�
2. Slowly return the pedal to the full back position.
When it stops, release your hand and press the
WRITE key.The name display will change from
OMIN� to OMAX.�
If you decide to halt the adjustment procedure, press the
EXIT switch. The power-on display will appear, and you
will enter Play mode.
3. Slowly advance the pedal. When it stops, release
your hand and press the WRITE key.
2. Press slowly3. Press slowly
The LCD display will indicate OCOMPLT� for
approximately one second. Then the power-on display
will appear, and you will enter Play mode.
After the adjustment procedure has been completed,
verify the operation of the pedal.
Select an effect that will make it easy to verify the
adjustment. For example, set the pedal effect block to
the VOLUME effect, set the value to 0, and check the
MIN level when the pedal is returned all the way.
If you make a mistake during the calibration procedure,
the LCD will indicate OERROR ,� and you will return to the
screen before the adjustment (the OMIN� display). If the
OERROR � display appears for repeated attempts, a
malfunction may have occurred. In this case, please
contact your dealer.
14 |
ACEC
